SMART3G-D3

The SMART 3G-D3 series gas detectors are used to detect, in areas classified as Zone 2, the presence of flammable substances (% LFL), toxic gases in ppm, refrigerant gases or for the detection of oxygen deficiency or excess.

The SMART3G-D3 is designed for use in all industrial environments thanks to the 4-digit luminous display that displays the measured gas concentration in real time and the high-brightness LED crown capable of signaling the 3 status levels.

The SMART3G-D3 allows non-intrusive on-site calibration using Hall effect sensors that allow you to operate the instrument using special magnets without having to open it or declassify the area.

SMART3G-D3 are ATEX Category 3 certified for Zone 2

High brightness Multi-color LED crown (display version)
Non-intrusive field calibration by magnetic pen
Bright 4-digit display and 5 status LEDs
Standard 4-20 mA signal on 3 wires
Standard 3 relay output
Optional RS485 interface for communication on Modbus protocol
Zero tracker to counter possible drift.
Continuous self-diagnosis of the system
ATEX: II 3G Ex db ec nC IIC T5 Gc
SIL 2 HW and SIL 3 SW certified
Wide range of usable sensors and detectable gases
Wide choice of accessories for installation and maintenance
Easy replacement of sensors.
Data logger exportable with STS / CKD-OLED or STS / CSW +
Degree of protection IP55

WRITE YOUR OWN REVIEW

How do you rate this product? *