MAD-432

Addressable control module of 2 supervised 24V outputs, for the activation of optical-acoustic signaling devices or maneuvers that require power, discriminating the fault of cut or short circuit in said line. It takes two loop addresses. Requires 24 Vdc auxiliary powers. LED status indicator. Connection through removable strips up to 2.5mm2 section. Possibility of being installed in DIN rail or flat to wall mounting in box BOX-ONE. Consumption less than 300μA at rest. Allows installation without polarity. Red color. Dimensions: 100 x 82 x 23 mm. CPR certificate EN54-18.

The range of MAD-400 modules has been developed to offer a wide and complete range of input and output ports to be used with Detnov’s addressable fire control panels. The MAD-400 modules allow performances and manoeuvres for the proper functioning of the fire detection system, monitoring and/or acting according to the needs of the installation. The MAD-400 modules have been designed to facilitate their installation process and they may be installed using screws or fitted into a DIN rail. Each module is equipped with removable terminal blocks and a LED status indicator. The addressing of the modules ir carried out through the PGD-200 programmer or auto addressing for isolator version. The MAD-431 and MAD-432 modules provide 1 or 2 supervised 24V outputs which may be configured through a micro-switch as supervised voltage outputs or a supervised conventional sounders output. When they are configured as sounder output, switching the sounder control panel’s key on and off will control the modules by switching the outputs of the modules on and off. The MAD-431 and MAD-432 modules require 24V auxiliary power and are assigned a number of loop addresses according to the number of inputs and outputs available in the module The MAD-431-I and MAD-432-I modules are equipped with integrated isolator. All the range of MAD-400 modules can be installed inside the BOX-ONE and BOX-SIX boxes.

° Simple installation on the wall or fitted into a DIN rail

° Non-polarity supported (only MAD-401 and MAD-402)

° Addressing through a programmer

° Requires an auxiliary 24V power supply

° Connections through removable terminal blocks and simple fitting of the cable

° EN 54-18 and EN 54-17 approved

WRITE YOUR OWN REVIEW

How do you rate this product? *