MAD-442
Addressable monitor module of 2 conventional zones, allows the connection of up to 20 conventional detectors and / or 32 conventional manual call points per zone. Can identify between detector alarm and push button, between the fault by cutting or by short circuit in the zone. It takes two loop addresses. Requires 24 Vdc auxiliary power. LED status indicator. Connection through removable strips up to 2.5mm2 section. Possibility of being installed in DIN rail or flat to wall mounting in box BOX-ONE. Consumption less than 300μA at rest. Allows installation without polarity. Red color. Dimensions: 100 x 82 x 23 mm. CPR certificate EN54-18.
The range of MAD-400 modules has been developed to offer a wide and complete range of input and output ports to be used with Detnov’s addressable fire control panels. The MAD-400 modules allow performances and manoeuvres for the proper functioning of the fire detection system, monitoring and/or acting according to the needs of the installation. The MAD-400 modules have been designed to facilitate their installation process and they may be installed using screws or fitted into a DIN rail. Each module is equipped with removable terminal blocks and a LED status indicator. The addressing of the modules ir carried out through the PGD-200 programmer or auto addressing for isolator version. The MAD-441 and MAD-442 modules provide 1 or 2 conventional zones which support up to 20 conventional detectors and/or 32 conventional manual call points. The conventional zone module is able to distinguish between a detector alarm and a manual call point alarm. The MAD-441 and MAD-442 modules require 24V auxiliary power (1) and are assigned a number of loop addresses according to the number of inputs and outputs available in the module The MAD-441-I and MAD-442-I modules are equipped with integrated isolator. All the range of MAD-400 modules can be installed inside the BOX-ONE and BOX-SIX boxes.
° Simple installation on the wall or fitted into a DIN rail
° Non-polarity supported (only MAD-401 and MAD-402)
° Addressing through a programmer
° Requires an auxiliary 24V power supply
° Connections through removable terminal blocks and simple fitting of the cable
° EN 54-18 and EN 54-17 approved
WRITE YOUR OWN REVIEW
How do you rate this product? *